Adjust a Jaw Tensioner®
Sleek, stainless steel tensioners that mount
on the outside of your post.
Easy to install
You can use our Invisiware® fixed tabs or threaded tabs (page 20) or lag eyes (page 21) to mount Adjust-A-Jaw® tensioners to your end posts. Or you can mount them using flat bar or angle iron welded to your post with holes drilled to accept the clevis. See the tabulated drawing and chart below to determine how this fitting interfaces with your end post. The clevis has a male thread that mates with the female thread within the body of the tensioner. The swaging ferrule is swaged onto the cable and holds the cable inside the body. The body rotates on the cable and provides a considerable amount of take-up during tensioning with an open-end wrench. After tensioning, the lock nut locks the
assembly in place.
